Upgrading to alloy wheels can dramatically improve your vehicle’s appearance and performance. However, proper installation is crucial to ensure safety, performance, and durability. At ALLOYHUB we have a dedicated fitting centre at our head office in Leek, Staffordshire where we ensure the wheels are fitting to your vehicle correct, however, if you are opting for your wheels to be fitting either by yourself or a third party, here is a step-by-step guide on how to properly install your alloy wheels.
Tools and Equipment You’ll Need:
- Car jack or hydraulic lift
- Jack stands
- Lug wrench or impact wrench
- Torque wrench
- Anti-seize lubricant (optional)
- New lug nuts (if applicable)
- Cleaning cloth (for cleaning the wheel hub)
- Gloves (for safety and cleanliness)
Step 1: Prepare Your Vehicle
- Park Your Car Safely: Ensure your vehicle is parked on a flat, stable surface. Turn off the engine, engage the parking brake, and place wheel chocks behind the wheels that won’t be lifted.
- Loosen the Lug Nuts: Use a lug wrench or impact wrench to loosen the lug nuts on the existing wheels. It’s best to do this while the vehicle is still on the ground so the wheels don’t spin.
Step 2: Lift the Vehicle
- Position the Jack: Place the jack under the vehicle’s recommended lifting points. If you’re unsure where these points are, check the owner’s manual for guidance.
- Lift the Car: Slowly raise the car until the wheel is off the ground. Ensure it’s high enough to easily remove the wheel and replace it with the alloy wheel.
- Secure with Jack Stands: For safety, always place jack stands under the car once it’s lifted. Never rely solely on the jack to hold the vehicle up while you’re working.
Step 3: Remove the Old Wheel
- Finish Loosening the Lug Nuts: With the vehicle safely lifted, remove the lug nuts completely. Keep them aside if you plan to reuse them or replace them with new ones if they’re worn or damaged.
- Take Off the Old Wheel: Gently pull the old wheel off the hub. If it’s stuck due to rust or corrosion, tap the side of the wheel with a rubber mallet to loosen it.
Step 4: Clean the Hub and Inspect
- Clean the Hub: Before installing the new alloy wheels, use a cloth to clean the wheel hub. Remove any dirt, rust, or debris that could affect the installation or cause uneven wear.
- Inspect the Brake Components: This is also a good time to inspect brake components (like rotors and pads) for any signs of wear or damage.
Should you be unsure on how to fit your alloy wheels on your vehicle, then feel free to contact a member of our team at ALLOYHUB.
Contact number – 0330 133 8271
Email – sales@alloyhub.com
